Formerly Bass Enhancer. If you tried the Bass Enhancer beta, move Bass Enhancer.vst3 out of your plug-in folder before you install Overtone. Your saved settings carry over.
Overtone makes bass and kick drums easier to hear on small speakers like phones, laptops and earbuds. Those speakers can't play the deepest notes, so Overtone adds higher tones that follow each low note, and you hear the bass through them. The original bass stays exactly as it was; Amount sets how much is added.
Install and open
You need a Mac with Apple silicon on macOS 13 or newer, or a 64-bit PC on Windows 10 or 11.
- Save your project and quit your DAW (your music software).
- Run the installer.
- Open your DAW. If Overtone doesn't appear, ask the DAW to rescan plug-ins.
- Add Lambda Audio → Overtone as an effect on your bass, kick, 808 or whole mix.
To start your 30-day free trial or enter a licence, click License / trial at the bottom left of the plug-in and sign in to your free Lambda Audio account. When the trial ends, Overtone lets your audio through untouched until you activate it, so your projects still open and play.
On a Mac, Overtone comes as a VST3 and as an Audio Unit. The Audio Unit is still experimental. If anything goes wrong, click Support next to License / trial and send the file it makes to support@lambdaaudio.com.
Quick start
- Play a loop with the bass in it, then click the preset name at the top and choose Default or Subtle Weight.
- Turn Amount up until the bass is clear at a normal listening volume. If it starts to sound fuzzy or obvious, back it off.
- Turn Character down for a warmer sound, or up for a grittier one.
- Set Focus to match your bass (see the table below).
- Click Match Level, wait three seconds, then use A/B to compare with and without Overtone at the same volume. Matching the volume keeps the test fair, since the louder version usually sounds better.
Overtone has no limiter. If the CLIP light comes on, turn Amount or Output down, then click CLIP to clear it.
The controls
| Control | What it does |
|---|---|
| Focus | Which low notes Overtone works from. Lower values work from the deepest sub-bass only; higher values take in more of the bass or kick. |
| Amount | How much is added. At zero, nothing is. |
| Character | Warm and smooth to the left, gritty and driven to the right. |
| Output | The final volume. |
Click ADVANCED for four more:
| Control | What it does |
|---|---|
| Range | How high the added tones reach. Shorter ranges blend in more quietly. |
| Consistency | Evens out quiet and loud notes, so every note gets similar help. |
| Punch Protect | Adds less on the hit of each note, so kicks and plucked bass stay sharp. |
| Added Width | How wide the added part is in stereo. Zero keeps it in the centre. Your original stereo is never changed. |
Quality at the top can stay on 4x. 8x uses much more CPU for a difference you'll rarely hear.
Hover over any control to read what it does. Double-click a knob to reset it, or type a value under it. The UNDO button takes back your last changes.
Match Focus to your bass
Set Focus to about twice the pitch of the lowest note the bass plays:
| Lowest note | Focus | Lowest note | Focus | |
|---|---|---|---|---|
| A0 | 55 | E1 | 82 | |
| B0 | 62 | F1 | 87 | |
| C1 | 65 | G1 | 98 | |
| D1 | 73 | A1 | 110 | |
| D#1/Eb1 | 78 | B1 | 123 |
Then play the lowest and highest notes. If the lowest note sounds thin, lower Focus. If the highest notes get no help, raise Focus or Consistency.
Kicks are tuned too, and the same rule works. If you don't know the note, the presets' Focus is a good starting point.
Listening tools
- HOLD: ADDED plays only what Overtone adds, while you hold it.
- Small Speaker cuts the deepest bass from what you hear, so you can check that the bass still comes through without it.
- Match Level with A/B compares the dry and processed sound at the same volume. Switch between HEARING DRY and HEARING ENHANCED. Any change you make clears the match, so measure again afterwards.
These three only change what you hear. Turn them off before you record a pass in real time. Exports skip them automatically.
Presets
Click the preset name at the top to open the library of 53 presets.
- Start Here has Default, then Subtle, Medium and Heavy Weight.
- Translation helps playback on phones, laptops, earbuds, cars and club systems.
- 808 & Synth Bass, Kick, Bass Guitar, and Instruments & Voice are for those sounds.
- Genre has presets for trap, house, rock and nine more styles.
- Mix Bus & Master works on a whole mix.
A few to try: 808 Growl for 808s, Kick Knock for kicks, Master Gentle Weight for a full mix. Sub Fuzz Extreme is a sound-design effect and can clip.
Hover over the preset name to read what it's for. Save current saves your settings as a preset file, and Open file loads one.
If something isn't right
- No difference: check that Bypass is off, Amount is up, and the track actually has bass for Overtone to work from.
- Harsh or fuzzy: lower Character, Amount or Range.
- The low end feels unsteady in stereo: lower Added Width.
- A/B isn't available: play some audio and click Match Level again.
- "Match failed": the two sides are too far apart in volume. Change Amount or Output and try again.